C10 / C20 CHEVY TRUCK HEADERS FROM THE WORLD'S LEADING HEADER MANUFACTURER!
Hedman Hedders has the largest selection of headers for the entire range of 1967-97 Chevy / GMC Trucks and SUVs. If you have a 1/2 or 3/4 ton pickup truck or Suburban, we manufacture a header to meet your specific needs. Choose from mid-length design models for maximum ground clearance and improved low-end performance, and full length designs that squeeze out the very last foot pound of torque when you run wide open throttle, or tow your toys to the river or woods. A variety of tube diameters are also available.
-Short, Mid-Length & Long
Tube Header Designs!
-50 STATE LEGAL to HARDCORE
-Factory Setup or ENGINE SWAP
-Mild Steel or 304 STAINLESS STEEL
Header Construction.
-RACE HEADERS Available!
-MADE IN USA Since 1954!
All Hedman C10 headers are made in the USA, and are covered by our limited lifetime warranty.
All models available in mild steel construction, and our most popular configurations are now available in 100% 304 Stainless Steel. Choose Between Standard Uncoated, HTC Polished Silver Ceramic, or Black Maxx Satin Black Ceramic Coated. All coatings are warrantied for a full Five Years.
***Unless otherwise stated in the information provided on this site, All HEDMAN HEDDERS are designed for use on stock cylinder heads. The use of aftermarket cylinder heads, or cylinder heads not original equipment on the listed vehicle, may result in component or chassis interference, as well as, sparkplug clearance. Always consult the head manufacturer before purchasing headers for use on AFTERMARKET or NON-STOCK heads, or contact the Hedman Tech Department at 562.921.0404 (8-4:30pm PST M-F).***
Dial in the right header for you Chevy Truck by narrowing your results with the useful filters below.
